CNC ELECTROHYDRAULIC PRESS BRAKE

The press brakes of the WAD series are born from the desire to protect the environment, focusing on energy saving, without compromising the efficiency of the machine. While in the traditional press brake the pump and the motor work continuously, in the servo system of the WAD series, if the pistons are at rest, the main pump and the motor will remain at rest, saving a lot of energy without affecting productivity.

CNC CONTROLLER

We offer DELEM, ESA and CYBELEC brand controls, patented by the Netherlands, Italy and Switzerland respectively.
The efficient processing system optimizes the bending operating cycle, reducing the time needed to set up the working phase and making bending more efficient, especially for batch processing.
In addition, the system can meet the editing of 2D and 3D graphics.

HYDRAULIC SYSTEM

It is a servo-assisted hydraulic control system with a short distance between cylinders. It has a strong load capacity, high synchronization accuracy and a high density-to-power ratio.
The pressure of the hydraulic system can be adjusted as needed to meet the strength and bending requirements.

MOTOR

The servo motor has become the strong point of our machines, allowing the improvement of the production efficiency of the machine at a low energy consumption and high dynamics. Compared to traditional engines, energy consumption can be reduced by 35%, with the advantage of high efficiency and low operating costs.

OIL PUMP

The oil pump is made of high strength cast iron, with an exclusive internal noise reduction design, low sensitivity to oil contamination and long service life.

BACKGAUGE

We use ball screws and linear guides to ensure more precise movement of the X axis.
The rear reference adopts a pulley mechanism controlled by a servo motor instead of a stepper motor.
The entire system is hardened at high temperature, which allows to completely eliminate internal stress, improve the plasticity and hardness of the metal and is not affected by any loss of precision caused by the deformation of the frame.

ELECTRICAL PARTS

The machines adopt original Schneider parts, which guarantee stability and durability over time. Equipped with original Estun electric box, with strong anti-interference capacity and good electrical performance.

CROWNING

The instrument calculates the value to be applied based on the total deformation of the piston and the work table, to perfectly adapt the deformation curve to the compensation curve and ensure the consistency of the straightness and the angle of the product.

PUNCHES AND DIES

Punches and dies of press brakes are one of the most important topics we will discuss before placing the order with the aim to equip the machine with a suitable set. We can provide the right tools according to different bending needs of customers.

RAPID CLAMP

The top punch is changed quickly to save time.

BALL SCREWS AND GUIDE

The ball screw and linear guide are used to ensure the proper functioning of the machine.

SERVO MOTOR

The servo motor controls the movement of the Y axis more precisely.

Looking for the best solution for you?

TORNA SU